Welcome To The Halloween-Master’s Website.


Free Halloween Multi Banner Exchange

Have a Halloween Idea or a DIY? Become a member and add a Link to your Site.

Bubbling Brew

Bubbling Brew

Materials:

  • one old turntable
  • one plastic cauldron
  • foam water noodles
  • a good stirring stick
  • a wig form and wig
  • 2 small pillows
  • old blankets
  • chicken wire
  • 3/4 inch pvc and fittings
  • wire coat hangers
  • wire ties
  • duct tape
  • spray paint (Black, green, brown)
  • wood

Tools:

  • a screw gun and screws
  • a staple gun
  • construction adhesive
  • carpet knife
  • tape measure/pencil

Step One: Prepare the base
First, we cut a piece of 2×6 wood about 13” long and screwed it to a piece of 1/2” plywood. We then used a smaller piece of 2×6 for the front of the base allowing for the turntable to fit snugly while allowing access for the motor and switch mechanisms to run unimpeded. Measure and cut your plastic cauldron so that it fits over your turntable. Next we drilled a hole in the back of the base just large enough for the 1/2 pvc pipe to fit. A 1×1 was attached to the base with an L-bracket and screws for support. We used a 45 degree fitting to hunch her back for a more realistic pose…..(More)

Share this:
Share this page via Email Share this page via Stumble Upon Share this page via Digg this Share this page via Facebook Share this page via Twitter

Leave a Reply

You must be logged in to post a comment.

eXTReMe Tracker